Instructions:
1 | INSTALL THE CLAMP LEVER
Slide the Clamp Lever (A) onto the Lever Dock (B). Press the lever down until it clicks into place. When the Clamp Lever is engaged, it will lay at a slight angle.
2 | REMOVE THE TRAVEL GUARD
Open the Skate Clamp by pressing and holding down the Clamp Lever. Remove the Travel Guard. Release the Clamp Lever.
3 | REMOVE THE TRAVEL SCREW
Remove the Travel Screw (A) by turning counter-clockwise until loose.
4 | STORING THE TRAVEL SCREW
Install the Travel Screw into the storage location on the Travel Guard (A) by turning clockwise until hand-tight. Do not over-tighten.
Transporting or moving the Sharpener without the Travel Guard & Travel Screw installed voids your Warranty and/or Extended Service Plan. Always remove the Travel Guard & Travel Screw before operating the Sparx Sharpener.
5 | PLUG IN THE POWER CORD
Plug the Power Cord into the Power Input Port on the back of the sharpener. Plug the other end into a wall outlet. Toggle the switch on the Power Input Port to the on position (I=on, 0=off).